HYOSUNG GV 650 C Owner's Manual page 72

BRAKE DISK INSPECTION
Check the brake disk for damage or cracks.
FRONT BRAKE FLUID SUPPLY
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the brake fluid reservior around not
to allow dust to get inside of it.
3. Loosen the screw and open the cap.
4. Replenish with brake fluid to the upper
line.
N O T E
The recommended brake fluid : DOT4
CAUTION
Don't replenish with brake fluid over
the limit line. It will leak out of the
brake fluid reservoir.
Be careful not to allow dusts or water
to go inside when it is replenished.
Don't use the unrecommended brake
fluid.
Brake fluid can damage severely the
plastics or rubbers. When it is spilt on
the parts, wipe them up immediately.
5. Fasten the cap.
REAR BRAKE FLUID SUPPLY
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the brake fluid reservior around not
to allow dust to get inside of it.
3. Turn the cap to the counter - clockwise.
4. Replenish with brake fluid to the upper
line.
N O T E
The recommended brake fluid : DOT4
5. Fasten the cap.
FRONT BRAKE LAMP SWITCH
The front brake lamp switch is located the
inside of the front brake lever. Loosen the
switch fitting screws and adjust the timing by
moving the switch body forward or back-
ward.
REAL BRAKE LAMP SWITCH
The rear brake lamp switch is located
inside the rear brake pedal.
Move the switch up or down to adjust it
until the switch operates and turns on the
brake lamp after the brake pedal begins to
be depressed.
71