4.6 Keyboard holder/Keyboard
4. Remove the keyboard.
Installing a keyboard
The following describes the procedure for installing a keyboard. (See Figure 4-7, 4-8.)
1. Set the keyboard on the palm rest with the back up and connect the keyboard cable to
the connector PJ3200 on the system board.
2. Turn down the keyboard on the palm-rest and insert the latches under the palm rest.
3. Fix the keyboard with the following screws.
PORTEGE A100 Maintenance Manual (960-460)
M2 4Z
BIND screw
4 Replacement Procedures
x2
4-15