Toshiba A100 VA3 - Satellite - Pentium Dual Core 1.6 GHz Maintenance Manual page 106

3.2 Executing the Diagnostic Test
Use the up and down arrow keys to move the cursor to "ERROR STOP".
Use the right and left arrow keys to move the cursor to the option to execute and press
Enter.
Selecting YES in ERROR STOP stops the test program when an error is occurred and
displays the error status. The operation guide will appear on the right side of the display as
shown below:
ERROR STATUS NAME
Press [1] Terminates the test program and returns to the subtest menu.
Press [2] Executes the next test.
Press [3] Restarts the test from the error.
Selecting NO in ERROR STOP displays the error status and increases error counter by
one if an error is occurred, and executes the next step.
6. Table 3-1 in section 3.3 describes the function of each test on the subtest menu. Table 3-4
in section 3.17 describes the error codes and error status for each error.
PORTEGE A100 Maintenance Manual (960-460)
[[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
3 Tests and Diagnostics
3-7