Table 1. Control Button Functions; Table 2. Led Indicator Status - Intel SE7501WV2 - Server Chassis - SR2300 Product Manual

Table 1. Control Button Functions
Power/Sleep button
Reset button
NMI button
ID button
Table 2. LED Indicator Status
Power/sleep LED
NIC 1 activity LED
NIC 2 activity LED
System status LED
Fixed disk drive
status LED
ID LED
Notes:
1 The Amber status takes precedence over the Green status. When the Amber LED is on or blinking, the Green
LED is off.
2 In order for a hard disk fault indication to occur, either an Intelligent Platform Management Interface (IPMI) based
satellite management controller must send a Set Fault Indication command to the Baseboard Management Controller
(BMC), or the system board must be used with the 2U SR2300 hot swappable backplane.
3 Also off when the system is powered off or in a sleep state.
4 The Power LED sleep indication is maintained on standby by the chipset. If the system is powered down without going
through BIOS, the LED state in effect at the time of power off will be restored when the system is powered on until the
BIOS clears it. If the system is not powered down normally, it is possible that the Power LED will be blinking at the
same time that the System Status LED is off due to a failure or configuration change that prevents the BIOS from
running.
12
Toggles the system power on/off. Or sleep button for ACPI compliant operating
systems.
Reboots and initializes the system.
Pressing the recessed button with a paper clip or pin issues a non-maskable
interrupt and puts the server in a halt state for diagnostic purposes.
Toggles on/off the front panel ID LED and the baseboard ID LED. The baseboard
ID LED is visible through the rear of the chassis and allows you to locate the
server you're working on from behind a rack of servers.
Continuous green light indicates the system has power applied to it.
(Note 4)
Blinking green light indicates the system is sleeping.
No light indicates the system does not have power applied to it (other than
5 V standby power).
Continuous green light indicates activity between the system and the network to
which it is connected.
Continuous green light indicates the system is operating normally.
Blinking green light indicates the system is operating in a degraded condition.
(Note 1)
Continuous amber light
nonrecoverable condition.
(Note 1)
Blinking amber light indicates the system is in a non-critical condition.
No light indicates POST/system stop.
Random blinking green light indicates fixed disk drive activity (SCSI or IDE).
(Note 2)
Continuous amber light
(Note 3)
No light indicates no fixed disk drive activity nor fault (SCSI or IDE).
Continuous blue light indicates ID button is depressed.
No light indicates ID button is not depressed.
Intel Server Chassis SR2300 Subassembly Product Guide
indicates the system is in a critical or
indicates fixed disk drive fault (SCSI or IDE).