Using The Command-Line Interface - Cisco AIR-BR350-A-K9 - Aironet 350 Wireless Bridge Hardware Installation Manual

Entering Basic Settings
To use Simplified Network Management Protocol (SNMP), enter a community name in the SNMP
Step 13
Admin. Community field. This name automatically appears in the list of users authorized to view and
make changes to the bridge's management system.
Click the SNMP link to go to the SNMP Setup page, where you can edit other SNMP settings.
You can define other SNMP communities with User Management. The "Security Setup" section in
Chapter 3 of the Cisco Aironet 350 Series Bridge Software Configuration Guide describes User
Management.
Click OK. The Setup page appears. If you changed the Role in Radio Network setting, your bridge
Step 14
reboots.

Using the Command-Line Interface

You can use a command-line interface (CLI) to configure your bridge through a terminal emulation
program or a Telnet session instead of through your browser. This section provides instructions for
Microsoft's HyperTerminal and for Telnet; other programs are similar.
Common Functions with the CLI
The CLI pages use consistent techniques to present and save configuration information.
the functions that appear on most CLI pages, and
Table 3-1
Function
Press Enter three
times
Ctrl-R
=
:back
:bottom
:down
Cisco Aironet 350 Series Bridge Hardware Installation Guide
3-8
Common Functions on CLI Pages
Description
Refreshes the page and cancel changes to settings.
Refreshes the page and cancel changes to settings.
Returns to the home page without applying changes.
Moves back one page without applying changes.
Jumps to the bottom of a long page, such as Event Log.
When you are at the bottom of a page, this function becomes
:top.
Moves down one page length (24 lines) on a long page, such
as Event Log. When you are at the bottom of a long page,
this function becomes :up.
Chapter 3
Figure 3-2 shows a CLI page example.
Basic Configuration
Table 3-1 lists
OL-1412-01