Axis 27980R1 User Manual page 57

Defining the
printer to PSF
Note:
AXIS 5570e User's Manual
Device Statement Explanation
Specifies:
JUNIT
1. The device address (host-connected, channel-attached, non-SNA printers
only). Do not specify a device address for the Axis Network Print Server when
using TCP/IP attachment.
2. The name of the processor to which the device is attached
3. A destination class for messages about the device
4 .Whether the device is initially online or offline
This parameter is required.
Specifies that the printer is managed by an FSS. This parameter is required.
MODE
Specifies which data-set processing mode is supported. For the Axis Network
PM
Print Server attached to Postscript printers, the correct setting is
PRMODE=(LINE,PAGE,)
sets can be printed.
Specifies the print output class that the printer is to process. You may want to
WC
consider handling disabled mechanisms by defining print classes.
Each Axis Network Print Server must be defined to PSF with a PRINTDEV
statement in the PSF startup procedure. The following keywords are
required on the PRINTDEV statement:
• IPADDR='xxx.xxx.xxx.xxx'
• PORTNO='xxxx'
The IPADDR parameter specifies the IP address of the Axis Network Print
Server in dotted-decimal notation.
Do not specify a host name in place of the dotted-decimal address.
The PORTNO keyword specifies the TCP/IP port to use for the print
session. This port number must match the port number set up for the Axis
Network Print Server in Configuring the Axis Network Print Server, on
page 42.
Below is a sample procedure,
your installation. The
PRINTDEV
and keywords. In the
PORTNO
number 5100 is used, but any port, larger that 1024, can be used as long
as the same port is set up in the Axis Network Print Server.
The procedure contains JCL parameters to produce a startup
APSWPROT
procedure for either 240-pel and 300-pel printers, but the references to
300-pel resolution are commented out. To create separate startup
procedures, make two copies of
commented instructions in
startup procedure for a resolution of 120 or 240 pels. In the second copy,
delete or comment out all references to 240-pel resolution, and make all
references to 300-pel resolution active. This changed copy is your startup
procedure for 300-pel resolution.
If you want to print both 240-pel and 300-pel AFP/IPDS jobs, create two
Setting Up - IBM Mainframe (zSeries)
, indicating that composed-page and line data
, which you can modify to suit
APSWPROT
statement includes the required
example below, the TCP/IP port
PRINTDEV
, and then follow the
APSWPROT
. Keep one unchanged copy as your
APSWPROT
IPADDR
57