Table of Contents
Advertisement
Setting Up - AS/400 (iSeries)
PPR/PPD Printing - IPDS Data Streams
Note:
Before you Begin
Configuring the
AS/400 Host System
Creating a PSF
Configuration
30
IPDS is only available for AXIS 5570e models with the IPDS option installed. For more
information, refer to Protocols and Datastreams, on page 9.
The configuration procedures presented in this section are divided into
three separate steps:
•
Configuring the AS/400 host
•
Configuring the AXIS 5570e
•
Verifying the communication between the AXIS 5570e and the AS/400
Make sure that the AS/400 host is running OS/400 V3R6 or higher with
TCP/IP support installed and configured.
Make sure that the latest PTFs are installed. Information about which
PTFs to use can be obtained from:
http://as400service.rochester.ibm.com/
When configuring the AS/400 host system you can:
•
create a PSF configuration
•
create a printer device description
The system uses default values but you can optionally create a PSF
configuration by following the instructions below:
1. Issue the command
2. Press F11 to display keywords.
3. Select a name for the PSF configuration and enter it at the
configuration (PSFCFG)
the numerals 0-9, but must begin with a letter. A maximum of 10 characters
are allowed.
4. Enter
at the
QGPL
Library
5. Enter
at the
*YES
IPDS pass through (IPDSPASTHR)
6. Enter
at the
*NORDYF
7. Enter
at the
*NOMAX
8. Press the Enter key on your keyboard to create the PSF configuration.
Many of the settings presented in the following panel example can be left
at their default settings. However, the settings that you must change are
highlighted in bold text and the settings that you must enter exactly as
shown in the example are highlighted in bold underlined text.
.
CRTPSFCFG
line. The name may comprise the letters A-Z and
line.
Activate release timer (ACTRLSTMR
Release timer (RLSTMR)
PSF
line.
) line.
line.
AXIS 5570e User's Manual
Advertisement
Table of Contents
