Axis 27980R1 User Manual page 54

Setting Up - IBM Mainframe (zSeries)
PRTnnnn Statement:
Note:
54
FSS Statement Explanation
Specifies the unique 1- to 8-character name of a particular FSS. This name is
FSS (fasname)
referenced in the
with this FSS. When you start the first printer that has an FSA definition for
that FSS, an FSS address space is created for PSF. PSF manages this FSS and the
printer FSA for the first printer. If you start a second printer with an FSA
definition for the same FSS, PSF manages a separate FSA for the second printer
in that FSS.
Specifies a procedure for starting the PSF FSS. The procedure, which must be
PROC
defined before that FSS is started, is a member of either SYS1.PROCLIB or a
library concatenated to SYS1.PROCLIB.
Specifies the 1- to 8-character name of the load module that is loaded into the
HASPFSSM
PSF FSS address space. This load module contains the various FSI service
routines that JES2 supplies. For PSF, specify the default value
(
HASPFSSM=HASPFSSM
A statement, which is required to define each printer
PRTnnnn
statement FSA, is associated with an
should have a unique
PRTnnnn
, , and
CNTL ENDCNTL PRINTDEV
specified in the parameter.
PROC
The label on the PRINTDEV statement must be 8 characters or fewer. PSF accepts the
PRTnnnn , PRINTnn , and PRINTERn formats. PRTnnnn is the recommended format.
The parameters create JES2 default values that are used unless
PRTnnnn
other values are specified in the application program JCL. The
statement contains the following parameters:
PRTnnnn
Explanation
Statement
Specifies the number of pages between data-set checkpoints. If checkpoint
intervals are too frequent, printer performance is significantly reduced. If
intervals are too infrequent, and a PSF error occurs, the job has to be
CKPTPAGE
reprocessed from the last checkpoint. In this case, printer performance is
significantly reduced if PSF errors continue to occur. The recommended
starting value is 100.
Specifies the output classes processed by the printer. By defining print classes
CLASS
you can handle disabled mechanisms.
Specifies the FSS for this device and must match the FSA name specified in
FSS
the corresponding FSS statement. This parameter is required.
Enables form markings to be placed on the job trailer pages. For the Axis
Network Print Server you should set this parameter to NO.
MARK
Note: This parameter is new in JES2 and replaces the MARK | NOMARK
parameter.
Specifies that the printer is managed by an FSS. This parameter is required.
MODE
statement for each printer FSA that is associated
PRTnnnn
).
statement. Each printer FSA
FSS
name that must match the label on the
statements for the PSF startup procedure
AXIS 5570e User's Manual
nnnn
PRTnnnn