Axis 27980R1 User Manual page 55

JES3 Initialization
Note:
FSSDEF Statement:
AXIS 5570e User's Manual
PRTnnnn
Explanation
Statement
Specifies the data-set processing modes supported for the printer. It lists all
the PRMODE values that the printer accepts. If the Axis Network Print Server is
connected to a PostScript printer, the correct setting is
PRMODE
PRMODE=(PAGE,LINE,)
and line data sets can be printed.
Enables job-header and job-trailer separator pages to be produced.
Note1: If the Distributed Print Function (DPF) of PSF/2 is installed, you may
SEP
need to set this parameter to
Note2: This parameter is new in JES2 and replaces the SEP | NOSEP parameter.
Enables formatted data-set header separator pages to be produced.
SEPDS
Note: This parameter is new in JES2 and replaces the SEPDS | NOSEPDS
parameter.
Specifies the way that the printer is started. The parameter value
that the printer is to be started by an operator command. The parameter value
specifies that the printer, if it is ready, is to start automatically when
YES
START
JES2 starts processing.
Note: This parameter is new in JES2 and replaces the DRAIN | START
parameter.
Specifies whether track-cell despooling is to be used or not. It is recommended
TRKCELL
to set this parameter to
Specifies a default font. If you want to select a font in the startup procedure
UCS
instead of the JES2 default font, you should set this parameter to
Below is sample JES3 statements for an TCP/IP attached Axis Network
Print Server. In the example the JNAME=PRT1 has been used.
FSSDEF,TYPE=WTR,FSSNAME=FSS3,PNAME=SAMPPRO3,SYSTEM=SYS1,TERM=NO
DEVICE,DTYPE=PRTAFP1,JNAME=PRT1,JUNIT=(,SYS1,,ON),FSSNAME=FSS3
MODE=FSS,PM=(LINE,PAGE,),CHARS=(YES,GT12),
CARRIAGE=(TES,A868),CKPNTPG=100,HEADER=YES,WC=(C)
This is only an example. For specific coding for JES parameters, refer to the JES publication
for the level of JES you are using.
The following paragraphs describe the JES3 initialization statements
shown above, which are typical of the JES3 statements used with PSF.
For more detailed descriptions of all JES3 initialization statements, refer
to the JES3 initialization and tuning publication for your operating
system.
The FSSDEF initialization statement is optional but recommended. If it is
omitted, JES3 generates a default FSS for the printer being invoked.
Setting Up - IBM Mainframe (zSeries)
.. This setting indicates that composed-page
.
YES
.
YES
specifies
NO
.
0
55