Table of Contents
Advertisement
Setting Up - IBM Mainframe (zSeries)
DEVICE Statement:
56
The FSSDEF statement can contain the following parameters:
FSSDEF
Explanation
Statement
Specifies that the FSS is an output writer for deferred printing. This parameter is
TYPE
required.
Specifies the unique name of a particular FSS. This parameter is required.
FSSNAME
Specifies a procedure for starting a specific PSF FSS. The procedure, which must
be defined before the FSS is started, is a member of the procedure library
defined by the
IATPLBST procedure library. Different FSSDEF initialization statements can refer
PNAME
to the same startup procedure.
The
PNAME
one of your organization's procedures.
Specifies the JES3 processor on which the FSS is run. The name must match the
SYSTEM
parameter in the
NAME
Specifies the way that the FSS is terminated. The parameter value
that the FSS is terminated if the JES3 global address space is terminated by a
TERM
*RETURN
A DEVICE statement is required for each printer. The DEVICE parameters
create JES3 default values that are used unless other values are specified
in the JCL application program. The DEVICE statement can contain the
following parameters:
Device
Explanation
Statement
CARRIAGE
Specifies the JES default page definition.
The value YES specifies that the page definition can be changed during
startup procedures.
The value NO specifies that the page definition cannot be changed during
startup procedures.
The value aaaa specifies that the un-prefixed name, 1 to 4 characters
long, of the page definition is to be used as default. The name specified
here, or the JES3 system default, is the PSF default page definition.
CHARS
Specifies a default JES3 font.
Specifies the number of pages between data-set checkpoints. If checkpoint
intervals are too frequent, printer performance is significantly reduced. If
intervals are too infrequent, and a PSF error occurs, the job has to be reprocessed
CKPNTPG
from the last checkpoint. In this case, printer performance is significantly
reduced if PSF errors continue to occur. The recommended starting value is 100.
Identifies the printer device type. For the Axis Network Print Server you should
DTYPE
specify the parameter value
Specifies a unique FSS for this printer DEVICE statement. The value must match
the value coded for the FSSNAME parameter in the corresponding FSSDEF
FSSNAME
statement.
Specifies if job and data set header pages are printed. If DPF is installed, you may
HEADER
need to specify HEADER=YES.
Specifies the name of the printer FSA. Each printer FSA should have a unique
JNAME. This unique JNAME is 8 characters or fewer and must correspond to its
JNAME
label on the
startup procedure specified in the
parameter of the STANDARDS statement or of the
STCPROC
parameter specifies either a startup procedure supplied with PSF, or
statement for the processor.
MAINPROC
or
operator command.
*DUMP
. This parameter is required.
PRTAFP1
,
, and
CNTL
ENDCNTL
PRINTDEV
parameter. This parameter is required.
PNAME
indicates
YES
statements for the PSF
AXIS 5570e User's Manual
Advertisement
Table of Contents
