PRESONUS STUDIOLIVE 16.4.2 - V1.12 User Manual page 57

2 Controls & Connections
2.10 Digital Effects | Master Control
Creating & Recalling a Scene
2. 1 0.2
If you enable Fader positions as a part of your
Scene recall, the StudioLive will automatically
put the meters in Fader Locate mode after
you press the Recall button. The Fader Locate
button will illuminate, and the meter section of
the Fat Channel will display the recalled fader position. Move the faders up or down until only the
center LED is illuminated in each meter. The subgroup and main meters at the top right of the
StudioLive will display the recalled positions for their respective faders. As long as you remain in
Fader Locate mode, the faders on your StudioLive will not be active. The level of the audio passing
through them will be set according to the stored fader position, not the current location. Once you
have recalled each of the faders to their Scene location, press the Locate button again. This will
take you out of Fader Locate mode and reactivate your faders so that they control the level of their
channels and buses.
If you enable knob positions as a part of your scene recall, all of the digital knobs (Aux 1-6 Outputs,
FXA and EFXB Levels, Cue, 2 Track In, Phones, Monitor, Aux Input A and Aux Input B knobs) will
remain at their stored position until they are moved manually. Once a knob is turned, its value will
jump to to the value of its current physical position. Therefore, if you intend to save and recall a
scene, it is highly recommended that you use the recall sheet provided in the back of this manual
to note the stored position of these controls.
A Quick Note About the AutoStore Feature
It is not necessary to create a scene for your StudioLive in order to remember its settings when
you power it down. Periodically, you will notice the Store button flash once, indicating that the
current settings on your StudioLive have been saved to internal memory. The StudioLive will take a
snapshot of the current position of every parameter on the mixer whenever no changes have been
made for ten seconds. If you wish to ensure that your StudioLive will hold its current settings before
you power down, simply wait for a few seconds until the Store button flashes. This is your indication
that it is now safe to turn off your StudioLive. The next time you turn it on, all of your settings will
be recalled automatically.
Please note: AutoStore does not change the settings for a recalled scene that has been altered.
Any changes made to a Scene in the StudioLive's library must be saved using the Scene menu, as
described in the first part of this section.
57