Dynamics & Eq; High Pass Filter - PRESONUS STUDIOLIVE 16.4.2 - V1.12 User Manual

2 Controls & Connections
2.3 The Fat Channel
Dynamics Processing and EQ
2.3.2
The main function of the Fat Channel is to provide dynamics processing and filtering for every input
and output on your StudioLive. The rotary encoders work in conjunction with the meters directly
above them to adjust the dynamics processing and EQ. The Fat Channel's processing section
consists of five parts: Hi Pass filter, Noise Gate, Compressor, Limiter, and semi-parametric EQ.
Each can be turned on or off and controlled separately. The signal flows as follows:
Phase Reverse button

High Pass filter

Gate On/Off button
Reverses the Phase of the Selected Channel.
Push this button to invert the phase of the selected
channel's signal (that is, to alter the phase by 180°). The
button will illuminate, indicating that the phase reverse is
active. The Phase Reverse button can be used to correct
audio signals that are out of phase and cancelling each
other out.
Phase reverse is only available on the 16 channels of the
input bus.
Engages the High Pass Filter.
The High Pass filter section consists of an encoder and a
meter. You will notice that the there is a frequency range
to the left of the meter. The high-pass filter's threshold
can be set from 24 Hz to 1 kHz. When the meter is set to
its lowest point, the filter is off.
Remember, that all frequencies below a high-pass filter's
threshold are attenuated. See section 5.3.1 for more
details.
The high-pass filter is only available on the 16 channels
of the input bus.
Turns the Gate On and Off for the Selected Channel.
This button engages and disengages the gate for the
selected channel. It will illuminate to indicate that the
gate has been enabled.
The gate is available for all input and output buses.
23