Metering Controls - PRESONUS STUDIOLIVE 16.4.2 - V1.12 User Manual

2 Controls & Connections
2.4 Metering

Metering Controls

2.4. 1
Below the System section of the StudioLive, you will find the Meters section. Each of these buttons
are toggle switches, meaning you can turn them on or off by simply pressing them and then pressing
them again. The meter state can also be changed by pressing another button in the Meter section,
any Select button on the StudioLive, or a Mix or Mix/Pan button in the Aux section.
It is important to mention that the meters simply overlay on the previously selected Fat Channel
state. For instance, if you have Channel 16 selected and then press the Output button in the Meter
section, the knobs and buttons in the Fat Channel section will still be active, and any changes made
will be applied even though they will not be reflected in the Meter section. The advantage of this is
that you can make adjustments in the Fat Channel, press a Meter button, and monitor your entire
mix, then press the same button to return to setting up your Fat Channel selection.
Input Metering Button
Output Metering Button
Gain Reduction Meter Button
Aux Metering Button
Fader Locate Button
Turns PFL Input Metering On and Off.
Switches the meters to display the pre-dynamics, pre-
fader level of the input bus. Meters are one to one (Meter
1 shows the level of Channel 1, etc.).
Turns Post-Fader Output Metering On and Off.
Switches the meters to display the post-dynamics, post-
fader level of the Input bus. Meters are one to one (Meter
1 shows the level of Channel 1, etc.).
Turns Gain Reduction Metering On and Off.
Displays the gain reduction of the input bus. Meters
are one to one (Meter 1 shows the gain reduction of
Channel 1, etc.).
Turns Aux Bus Master Out Metering On and Off.
Displays the output level of each of the aux sends.
•
Meters 1, 3, 5, 7, 9, and 11 display the output
levels of Aux Sends 1-6, respectively.
•
Meters 13 and 15 display the output level of
EFX A and EFX B.
Turns Fader-Recall Metering On and Off.
Displays the fader position of the stored scene. When
recalling a fader position, adjust the fader until only the
center LED is visible in its meter.
36