The Aux Bus; Analog Aux Sends - PRESONUS STUDIOLIVE 16.4.2 - V1.12 User Manual

2 Controls & Connections

The Aux Bus

2.6
The StudioLive has six analog aux sends and two internal effects sends. The aux sends are mono;
however, two aux sends can be linked to create a stereo bus. Section 5.6 discusses how to use
these aux buses for monitor and effects mixing.

Analog Aux Sends

2.6. 1
Solo Button
Post-Fader Send Button
Output Level Control
Turns Soloing On and Off.
This button will solo the aux bus to the main outputs or to
the monitor outputs, depending on whether PFL or SIP is
selected in the Solo bus section. Please review Section
5.8 for details.
When a Solo button is enabled, that channel or bus will
automatically be selected, and its Select button will
illuminate.
Enables and Disables Post-Fader Send.
When this button is enabled, the send levels to that
aux send will be post-Fat Channel and post-fader, and
therefore are affected by fader settings. If the button is
disabled, by default, the aux buses use the Pre 1 setting,
and all channels on your StudioLive are sent to the aux
bus after the phase reverse switch, high pass filter, and
noise gate but before the compressor, EQ, limiter, and
fader. However, in the System Menu you can select the
Pre 2 setting, to move the send after all Fat Channel
processing but before the fader. Please review Section
2.10.4 for details.
Adjusts the Master Output Level of the Aux Send.
This knob adjusts the master output level of the aux send.
39