Quick "How To" Operate The Spa - Manually; Guide Operate The Spa - Automatically - Hayward OnCommand Operation Manual

Multifunction pool controller

Hide thumbs Also See for OnCommand:

Installation manual (32 pages)

Operation manual (32 pages)

Installation manual (32 pages)

Table Of Contents

Table of Contents

Remote Menus

Enabled

This feature will prevent unauthorized access to the Settings, Timers, and Configuration menus from

any of the OnCommand's remote display/keypads. When disabled, the remote display/keypads will

only show the default menu and allow on/off control via the pushbuttons. Note that the function of

the OnCommand's built-in display/keypad is unchanged by this selection. Once disabled, the only

way to enable "Remote Menus" is to use the local display/keypad.

All Timeclocks

7-day

This selection affects ALL of the timeclock logic in the OnCommand. If "7-day" is selected, each

timeclock will have one set of turn-on/turn-off settings that operate every day of the week. If "Weekend/

Weekdays" option is selected then the user can enter one set of turn-on/turn-off times for the weekend

(fixed as Saturday/Sunday) and another set of turn-on/turn-off times for weekdays (Monday through

Friday).

Time Format

12 hour AM/PM

Units

ºF and PPM

Reset Config. to

Default

Press +

Are you sure?

+ to proceed

Config. reset

Confirmed

Use this function to erase all previous system configuration and reset all configuration parameters

back to the factory default values. This function is NOT reversible--be careful.

Operate the Spa—Manually

1. Press the "Pool/Spa" button to go to "spa-only" operation (right LED illuminated). In some cases,

this may take more than one press of the button.

2. If the filter pump is not already on, press the "FILTER" button to turn it on.

3. If the spa is below the desired temperature, the heater will turn on automatically when the filter pump

is on and the valves are in the spa-only position. If you have not already set the desired temperature

for the spa, see "Set Heater Temperature" below.

4. If the spa has a separate jet pump and or blower, determine if the jet pump/blower is controlled by

Aux1 or Aux2 (it should be marked on the label inside the door). Then press the appropriate button

to turn on the jets/blower.

Operate the Spa—Automatically

1. Press the "MENU" button repeatedly until "Timers Menu" is displayed.

2. Press the ">" button repeatedly until the "Spa—all" or "Spa—wkend" is displayed.

3. Use the "+" and "-" buttons to set the desired start time, then press ">" to switch to the off time. Use

the "+" and "-" buttons to adjust the off time. If you are setting the "weekend" timeclock, press ">" to

go to the "weekday" settings.

Toggle between Enabled (default) and Disabled Remote Menus