Hayward OnCommand Operation Manual page 2

Multifunction pool controller
Hide thumbs Also See for OnCommand:
Table of Contents

Advertisement

IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be
followed, including the following:
READ AND FOLLOW ALL INSTRUCTIONS
WARNING: Disconnect all AC power during installation.
!
WARNING: Water in excess of 100 degrees Fahrenheit may be
!
hazardous to your health.
WARNING: To reduce the risk of injury, do not permit children to
!
use this product unless they are closely supervised at all times.
A green colored terminal marked "Earth Ground" is located inside the wiring
compartment. To reduce the risk of electric shock, this terminal must be
connected to the grounding means provided in the electric supply service
panel with a continuous copper wire equivalent in size to the circuit conductors
supplying the equipment.
A wire connector is provided on this unit to connect a minimum 8 AWG (8.4
mm) solid copper conductor between this unit and any metal equipment,
metal enclosures of electrical equipment, metal water pipe, or conduit within
5 feet (1.5m) of the unit, to connect the equipment assembly or spa to a
circuit protected by a ground-fault circuit-interrupter.
SAVE THESE INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OnCommand and is the answer not in the manual?

Questions and answers

RICK REIGLE
April 23, 2025

The pump does not run. Message is "Pool Bridge Down"

This manual is also suitable for:

OncomOncom-actOncom-rcOncom-act-rc

Table of Contents

Save PDF