Hayward OnCommand Operation Manual page 11

Pool Low Speed
50%
This setting will appear if "spa only" is not selected and variable speed filter pump is enabled. This
setting determines the speed of the pump during low speed pool or spillover operation. This value
can be set from "Lowest Speed" to 50% in 5% increments. 50% is default.
Set Day and Time Set Day and Time
Wednesday 10:37P 10:37P
Set Day and Time
Wednesday 37
Set Day and Time
Wednesday 10: P
Use this function to set the current day of the week and time. These values are used for all the
automatic timeclock functions of the OnCommand and are also displayed as part of the default menu.
The OnCommand is designed to keep the clock running during power outages lasting less than 7
days. If power has been off for longer than 7 days, then the time may have to be reset.
Display Light
On for 60 sec
This function controls the backlight on the display. If the "60 seconds" option is selected, then the
backlight will automatically turn off 60 seconds after the last key is pressed and will stay off until next
time a key is pressed.
Note that the Display Light selection only applies to the display keypad that you are currently using.
Other display/keypads will not be affected. In other words, you need to individually set this option
for each display/keypad in the system.
Beeper
Enabled
When "Enabled", the keypad will beep every time a key is pressed. If this audible indication is not
desired, select "Disabled".
This function only applies to the display/keypad that you are currently using. You need to set this
option for each display/keypad in your system.
NOTE: This function is not supported on all display/keypads. If the "Enabled" selection is not
blinking, then the current software revision of that particular keypad/display does not support the
option and it will default to Beeper Enabled.
Adjust the desired low speed for variable speed operation
Move to previous/next menu item
Adjust the current day of the week
Move to hours setting
Adjust the current hour (including AM/PM if applicable)
Move to minutes setting
Adjust the current minute
Move to previous/next menu item
Toggle between Always On and On for 60 sec.
Move to previous/next menu item
Toggle between Enabled (default) and Disabled Beeper
Move to next menu item
8