Hayward OnCommand Operation Manual page 10

Multifunction pool controller

Hide thumbs Also See for OnCommand:

Installation manual (32 pages)

Operation manual (32 pages)

Installation manual (32 pages)

Table Of Contents

Table of Contents

Super Chlorinate

Off

This display only appears if the external chlorinator is enabled.

When you have an unusually high bather load, a large amount of rain, a cloudy water condition, or

any other condition that requires a large amount of chlorine to be introduced to the pool, activate the

OnCommand Super Chlorinate function. The OnCommand will turn on the filter pump, set the pool/

spa valves to the correct position, and set the external chlorine generator to maximum output. The

super chlorinate function will continue for the programmed number of hours (see Timers/Super

Chlorinate Hours below) overriding the normal filter pump timeclock settings. At the end of the super

chlorinate period, the pool will return to normal operation.

If you manually turn off the filter pump (using the FILTER button on any display/keypad), the super

chlorinate function terminates. When you turn the filter pump back on, super chlorinate will resume

for the balance of the programmed number of hours.

Spa Chlorinator

This setting will appear only if the system has been setup for external chlorinator and "spa only" or

"pool and spa". It will determine the external chlorinator output when the system is operating in spa-

only mode. The actual amount of chlorine introduced into the spa is determined by this setting, the

amount of time the pool operates in spa-only mode, the water temperature, and the amount of salt in

the water. If the filter pump is running due to the freeze protection feature, then the chlorinator will not

operate during this time.

Pool Chlorinator

60%

This setting will appear only if the system has been setup for external chlorinator and "pool only" or

"pool and spa". It will determine the chlorinator output when the system is operating in pool only or

spa spillover modes. The actual amount of chlorine introduced into the pool is determined by this

setting, the amount of time the filter pump is running, the water temperature, and the amount of salt in

the water. If the filter pump is running due to the freeze protection feature, then the chlorinator will not

operate during this time.

Spa High Speed

100%

This setting will appear if "pool only" is not selected and variable speed filter pump is enabled. This

setting determines the speed of the pump during high speed spa operation. This value can be set from

20% to "Highest Speed" in 5% increments. "Highest Speed" is default.

Spa Low Speed

50%

This setting will appear if "pool only" is not selected and variable speed filter pump is enabled. This

setting determines the speed of the pump during low speed spa operation. This value can be set from

"Lowest Speed" to 50% in 5% increments. 50% is default.

Pool High Speed

100%

This setting will appear if "spa only" is not selected and variable speed filter pump is enabled. This

setting determines the speed of the pump during high speed pool or spillover operation. This value

can be set from 20% to "Highest Speed" in 5% increments. "Highest Speed" is default.

Turn super chlorinate on or off