Quick "How To" Operate The Spa - Manually; Guide Operate The Spa - Automatically; Set The Heater Temperature; Set The Chlorinator Output - Hayward Goldline Controls Aqua Logic AQL-P-4 Operation Manual

Operate the Spa—Manually
1. Press the "Pool/Spa" button to go to "spa-only" operation (right LED illuminated). In some
cases, this may take more than one press of the button.
2. If the filter pump is not already on, press the "FILTER" button to turn it on.
3. If the spa is below the desired temperature, the heater will turn on automatically when the filter
pump is on and the valves are in the spa-only position. If you have not already set the desired
temperature for the spa, see "Set Heater Temperature" below
4. If the spa has a separate jet pump and or blower, determine if the jet pump/blower is con-
trolled by Aux1 or Aux2 (it should be marked on the label inside the door). Then press the
appropriate button to turn on the jets/blower.
Operate the Spa—Automatically
1. Press the "MENU" button repeatedly until "Timers Menu" is displayed
2. Press the ">" button repeatedly until the "Spa—all" or "Spa—wkend" is displayed.
3. Use the "+" and "-" buttons to set the desired start time, then press ">" to switch to the off
time. Use the "+" and "-" buttons to adjust the off time. If you are setting the "weekend"
timeclock, press ">" to go to the "weekday" settings.
Note: During the programmed spa time, the valves will automatically switch to the
"spa-only" position, the filter pump will turn on, and, if the spa is not up to the desired
temperature, the heater will start. This operation is the highest priority and will take
precedence over other automatically programmed operations. At the end of the spa
period, the Aqua Logic will return to its normally programmed operation state.
Set the Heater Temperature (or turn heater permanently off)
1. Press the "MENU" button repeatedly until "Settings Menu" is displayed
2. Press the ">" button repeatedly until the "Spa Heater1" or "Pool Heater1" is displayed.
3. Press the "+" or "-" buttons repeatedly to adjust the temperature. If you adjust the tempera-
ture below 65ºF or above 104°F the display will indicate "off" and the heater will not operate
regardless of temperature.
Note: Separate temperatures for the pool and spa must be set. If the valves are in the
pool-only or spa spillover positions, then the heater will use the pool setting. If the
valves are in the spa-only position then the heater will operate according to the spa
setting.

Set the Chlorinator Output

1. Press the "MENU" button repeatedly until "Settings Menu" is displayed
2. Press the ">" button repeatedly until the "Spa Chlorinator" or "Pool Chlorinator" is displayed.
3. Press the "+" or "-" buttons repeatedly to adjust the setting. If you adjust the setting to 0% the
chlorinator will be off all the time
Quick "How To" Guide
22