Ricoh Aficio MP 301SPF User Manual page 173

Message
"Cannot connect with the
Bluetooth interface. Check
the Bluetooth interface."
"Hardware Problem:
Ethernet"
"Hardware Problem: HDD"
"Hardware Problem: Parallel
I/F"
"Hardware Problem: USB"
"Hardware Problem:
Wireless Card"
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless
card".)
Causes
• The Bluetooth interface
unit was installed while
the machine was turned
on.
• The Bluetooth interface
unit was removed while
the machine was turned
on.
An error has occurred in the
Ethernet interface.
An error has occurred in the
hard disk.
An error has occurred in the
IEEE 1284 interface board.
An error has occurred in the
USB interface.
The wireless LAN board can
be accessed, but an error
was detected.
When Messages Are Displayed on the Control Panel
Solutions
Turn off the main power switch, and
then confirm that the Bluetooth
interface unit was installed correctly.
And then, turn on the main power
switch again. If the message appears
again, contact your service
representative.
Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
Turn off the main power switch, and
then confirm the wireless LAN board is
inserted correctly. And then, turn on the
main power switch again. If the
message appears again, contact your
service representative.
171