Connecting To Ssms - Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Manual

Chapter 6

Connecting to SSMs

Connecting to SSMs
Cisco ASA 5500 Series Getting Started Guide
6-4
Connecting Interface Cables on the ASA 5500, ASA 5510, ASA 5520, and ASA 5540 Platforms
Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop
bits, and Flow Control (FC) = Hardware.
Locate the serial console cable, which has an RJ-45 connector on one end and
b.
a DB-9 connector on the other end for the serial port on your computer.
Connect the RJ-45 connector to the Console port of the adaptive security
c.
appliance as shown in
Connect the DB-9 connector to the console port on your computer.
d.
Figure 6-2 Connecting the Console Cable
FLASH
1 RJ-45 Console port
SSMs are optional; this procedure is necessary only if you have installed an SSM
on the adaptive security appliance.
Figure 6-2.
1
2
2
RJ-45 to DB-9 console cable
78-19186-01