Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Manual page 197

Chapter 14 Configuring the CSC SSM
Choose the interface from the drop-down list. Available options are global (all
Step 13
interfaces), inside, management, and ssm management.
Choose the source of network traffic from the IPv4 Network Objects list, and click
Step 14
OK.
To specify the destination of network traffic for the CSC to scan, click the ellipses
Step 15
to display the Browse Destination dialog box.
Choose the destination of network traffic from the IPv4 Network Objects list, and
Step 16
click OK.
To specify the type of service for the CSC to scan, click the ellipses to display the
Step 17
Browse Service dialog box.
Choose the service(s) from the list, and click OK.
Step 18
Enter a description for the network traffic that you want the CSC to scan in the
Step 19
field provided.
To specify whether or not to allow the CSC to scan network traffic if it fails, do
Step 20
the following:
•
•
•
•
78-19186-01
Scenario: Security Appliance with CSC SSM Deployed for Content Security
To allow traffic through without being scanned, click Permit.
To prevent traffic from going through without being scanned, click Deny.
To save your settings, click OK. The added traffic details appear on the
Traffic Selection for CSC Scan screen.
To discard these settings and return to the Traffic Selection for CSC Scan
screen, click Cancel. If you click Cancel, ASDM displays a dialog box to
confirm your decision.
Cisco ASA 5500 Series Getting Started Guide
14-15