Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Manual page 40

Connecting Interface Cables
b.
Connect to fiber Ethernet ports to be used for network connections.
Step 6
Note
For each fiber port you want to use, perform the following steps:
a.
Figure 3-14
1
b.
Cisco ASA 5500 Series Getting Started Guide
3-18
Connect the other end of the Ethernet cable to a network device, such as a
router, switch or hub.
Slot 1 contains four copper Ethernet ports and four fiber Ethernet ports.
You can use both types of ports, but you can only have a total of four
Slot 1 ports in use at a time. For example, you could use two copper
Ethernet ports and two fiber Ethernet ports.
Install the SFP module:
Insert and slide the SFP module into the fiber port until you hear a click.
–
The click indicates that the SFP module is locked into the port.
Remove the port plug from the installed SFP as shown in
–
Removing the Fiber Port Plug
2
1
Port plug
Connect the LC connector to the SFP module as shown in
Chapter 3
2
SFP module
Installing the ASA 5550
Figure 3-14.
Figure 3-15.
78-19186-01