Connecting The Interface Cables - Cisco ASA 5510 Quick Start Manual

Figure 2 Rack Mounting the Chassis

Connecting the Interface Cables

To connect the interface cables, perform the following steps:
Connect a computer or terminal to the adaptive security appliance for management access.
Step 1
Before connecting a computer or terminal to the Console port, check the baud rate. The baud
Note
rate must match the default baud rate (9600 baud) of the console port on the adaptive security
appliance. Set up the computer or terminal as follows: 9600 baud (default), 8 data bits, no
parity, 1 stop bits, and FC=hardware.
Locate the blue console cable from the accessory kit. The console cable has an RJ-45
Step 2
connector on one end and a DB-9 connector on the other.
6
CI SC O
AS A 55
PO WE R Ad ap tiv 40
ST AT US SE RIE
e Se cur
AC TI VE S
ity Ap pli
VP N an ce
FL AS H