Sfp Module - Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Manual

Chapter 5 Installing Optional SSMs

SFP Module

Note
Table 5-3 Cabling Requirements for Fiber-Optic SFP Modules
62.5/125 micron
Multimode 850
SFP Module nm Fiber
—
LX/LH
275 m at
SX
200 Mhz-km
78-19186-01
The adaptive security appliance uses a field-replaceable SFP module to establish
Gigabit connections.
If you install an SFP module after the switch has powered on, you must reload the
adaptive security appliance to enable the SFP module.
Table 5-2 lists the SFP modules that are supported by the adaptive security
appliance.
Table 5-2 Supported SFP Modules
SFP Module
1000BASE-LX/LH
1000BASE-SX
The 1000BASE-LX/LH and 1000BASE-SX SFP modules are used to establish
fiber-optic connections. Use fiber-optic cables with LC connectors to connect to
an SFP module. The SFP modules support 850 to 1550 nm nominal wavelengths.
The cables must not exceed the required cable length for reliable communications.
Table 5-3 lists the cable length requirements.
50/125 micron
Multimode 850
nm Fiber
—
550 m at
500 Mhz-km
Type of Connection
Fiber-optic
Fiber-optic
62.5/125 micron 50/125 micron
Multimode Multimode
1310 nm Fiber 1310 nm Fiber
550 m at 550 m at
500 Mhz-km 400 Mhz-km
— —
Cisco ASA 5500 Series Getting Started Guide
Cisco 4GE SSM
Cisco Part Number
GLC-LH-SM=
GLC-SX-MM=
9/125 micron
Single-mode
1310 nm Fiber
10 km
—
5-5