Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 - ADMINISTRATION Administration Manual page 82

Password Override: This feature allows an administrator to set a password override that can
temporarily disable the policy for a specified period of time. Check the Password Override box
and enter the password in the provided field. Enter the password again in the confirmation
field. Use this password in the Override Password Generator to generate the password key for
this policy.
WARNING: It is highly recommended that end users are not given this password, rather the
Override Password Generator should be used to generate a temporary key for them.
Uninstall Password: We recommend that every Endpoint Security Client be installed with an
uninstall password to prevent users from uninstalling the software. This password is normally
configured at installation; however, the password can be updated, enabled, or disabled via
policy.
The default setting is Use Existing, which will not change the uninstall password.
Enabled is used to either activate an uninstall password or to change it. Enter the new
password and confirm it.
Disabled is used to deactivate the uninstall password requirement.
Use Policy Update Message: You can display a custom user message whenever the policy is
updated. Click on the check box, then specify the message information in the provided boxes.
Use Hyperlink: A hyperlink to additional information, corporate policy, or other related
information can be included at the bottom of the custom message (see
"Hyperlinks," on page 124
box displayed to the user.
Figure 6-6
Wireless Control
Wireless Control globally sets adapter connectivity parameters to secure both the endpoint and the
network. To access this control, click the Global Policy Settings tab, then click the Wireless Control
icon in the policy tree on the left.
82 ZENworks Endpoint Security Management Administration Guide
for more information). The following is an example of the dialog
Updated Policy Custom Message with Hyperlink
Section 6.3.4,