Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 - ADMINISTRATION Administration Manual page 101

Hide thumbs Also See for ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 - ADMINISTRATION:
Table of Contents

Advertisement

NOTE: You can set the communication hardware controls globally on the Global Policy Settings
tab or for individual locations on the Locations tab.
To access this control:
To set the communication hardware controls for a location, click the Locations tab, expand the
desired location in the tree, then click Comm Hardware.
or
To set the communication hardware controls on a global basis, click the Global Policy Settings tab,
expand Global Settings in the tree, then click Comm Hardware. For more information, see
"Communication Hardware" on page
Location Communication Hardware Control
Figure 6-18
To configure the settings:
1 For each communication hardware type listed below, select Apply Global Settings, Allow All
Access, or Disable All Access:
1394 (FireWire): Controls the FireWire access port on the endpoint.
IrDA: Controls the infrared access port on the endpoint.
Bluetooth: Controls the Bluetooth access port on the endpoint.
Serial/Parallel: Controls serial and parallel port access on the endpoint.
84.
Creating and Distributing Security Policies 101

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 - ADMINISTRATION and is the answer not in the manual?

Table of Contents