Global Policy Settings - Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 - ADMINISTRATION Administration Manual

Section 6.2.4, "Compliance Reporting," on page 118
Section 6.2.5, "Publishing Security Policies," on page 121
Security policies are built by defining all the Global Settings (default behaviors), then creating and
associating existing components for that policy, such as locations, firewalls and integrity rules, and
finally establishing compliance reporting for the policy.
The components are created either within a dummy policy or are associated from other policies. It is
assumed that for your first few policies you are creating all of the unique locations, firewall settings
and integrity rules for the enterprise. These components are stored in the Management Service's
database for possible later use in other policies.
The diagram below shows the components for each level and a resulting policy taken from the
selections.
Figure 6-4

6.2.1 Global Policy Settings

The global policy settings are applied as basic defaults for the policy. To access this control, in the
Management Console, click the Global Policy Settings tab.
80 ZENworks Endpoint Security Management Administration Guide
ZENworks Endpoint Security Management Security Policy creation process