Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 - ADMINISTRATION Administration Manual page 108

Filtered Access Points
Access points entered into the Filtered Access Points list are the only access points that display in
Zero Config; this prevents an endpoint from connecting to unauthorized access points.
Figure 6-24
Enter the following information for each access point:
SSID: Identify the SSID number. The SSID number is case sensitive.
MAC Address: Identify the MAC Address (recommended, due to the commonality among
SSIDs. If not specified, it is assumed there will be multiple access points beaconing the same
SSID).
Prohibited Access Points
Access points entered into the Prohibited Access Points list do not display in Zero Config, nor will
the endpoint be permitted to connect to them.
Figure 6-25
Enter the following information for each access point:
SSID: Identify the SSID number. The SSID number is case sensitive.
MAC Address: Identify the MAC Address (recommended, due to the commonality among
SSIDs. If not specified, it is assumed there will be multiple access points beaconing the same
SSID).
Wi-Fi Security
If Wi-Fi Communication Hardware (Wi-Fi adapter PCMCIA or other cards, and built-in Wi-Fi
radios) is globally permitted (see
to the adapter at this location.
To access this control, click the Locations tab, then click Wi-Fi Security in the policy tree on the left.
108 ZENworks Endpoint Security Management Administration Guide
Filtered Access Points Control
Prohibited Access Points Control
"Wireless Control" on page 82), additional settings can be applied