Table of Contents
Advertisement
7.2.2 Running a Report from Crystal Reports Server
To run a report:
1 Click the Analysis tab.
2 In the Analysis Navigator, click a report from the available reports.
NOTE: To run any Top 10 reports, aggregation must be enabled and
in
DAS_Binary.xml
Section 11.10, "Report Data Configuration," on page
3 Click Analysis > Create Report or click Create Report.
4 Complete the information prompts and click OK. The report displays.
7.2.3 Running an Event Query Report
To create an Event Query report:
1 Click the Analysis tab.
2 In the Analysis Navigator, open the Historical Events folder.
3 Click Historical Event Queries.
4 Click Analysis > Create Report or click Create Report icon. An Event Query window displays.
5 Set the following:
time frame
filter
severity level
batch size (this is the number of events to view – events display from oldest events to
newer events)
6 Click Begin Searching.
7 To view the next batch of events, click More results icon.
8 Rearrange the columns by dragging and dropping them and arrange the sort order by clicking in
the column heading.
9 When your query is complete, it is added to the list of quick queries in the Navigator.
7.3 Offline Query
Offline Query is most often used to run queries against large amounts of data. Offline Query will
continue to run even after the user logs out of the Sentinel Control Center, if necessary.
NOTE: You can view the result of your query only after it is completely processed.
156 Sentinel 6.1 User Guide
must be set to on. For information on how to enable aggregation, see
EventFileRedirectService
266.
Advertisement
Table of Contents
