Table of Contents
Advertisement
6 Select Solution Designer, Solution Manager, or Solution Pack (which will automatically select
both child permissions). The new permissions will be applied the next time the user logs in.
15.2 Solution Manager
After a Solution Pack is imported, the Solution Manager in the Sentinel Control Center is used to
install, implement and test each Control.
Installing a Control installs the child content for the Control into the Sentinel system. When the
content is initially installed, its status is Not Implemented.
Implementing a Control is the process to configure event source systems and Sentinel to use the
content associated with the Control. Novell Solution Packs include detailed documentation
describing implementation steps. The user should change the status of the Control to
Implemented after following all of these steps.
Testing a Control is the process to verify the content associated with the Control. Novell
Solution Packs include detailed documentation describing testing steps. The user should
change the status of the Control to Tested after following all of these steps.
To use the Solution Manager, a user must be assigned Solution Manager permissions under Solution
Pack. For more information, see
page
333.
15.2.1 Solution Manager Interface
The Solution Manager window is divided into two frames: Content and Documentation.
334 Sentinel 6.1 User Guide
Section 15.1.2, "Permissions for Using Solution Packs," on
Advertisement
Table of Contents
