Table of Contents
Advertisement
2.8.5 Planning the NetWare Agent Installation
Aside from the cluster-specific issues discussed in the preceding sections, the considerations
involved in planning to install the GroupWise NetWare agents are the same in a clustering
environment as for any other environment. Review
and fill out the
"GroupWise Agent Installation
GroupWise 7 Installation Guide
POA.
Fill out the NetWare Agent Worksheet, taking into account the following cluster-specific issues:
GROUPWISE AGENT INSTALLATION WORKSHEET
Under
Item 2: Agents and
clustering environment, a domain or post office and its agent must reside on the same GroupWise
volume in order to fail over together.
Under
Item 3: Installation
Path, take into account your decision based on
the Agent Software" on page
Under
Item 4: Configure GroupWise Agents for
Installation program to customize the agent startup files for clustering.
Under
Item 6: Domains
and
filled out in
Section 2.3, "Planning a New Clustered Domain," on page 25
New Clustered Post Office," on page
"Planning Secondary IP Addresses and Cluster-Unique Port Numbers for Agents in the Cluster" on
page
31.
Under
Item 10: Launch GroupWise Agents
protected mode later.
IMPORTANT: Do not install the NetWare agent software until you are instructed to do so in
Chapter 3, "Setting Up a Domain and Post Office in a NetWare Cluster," on page
Skip to
Chapter 3, "Setting Up a Domain and Post Office in a NetWare Cluster," on page
2.9 GroupWise Clustering Worksheets
Section 2.9.1, "System Clustering Worksheet," on page 37
Section 2.9.2, "IP Address Worksheet," on page 40
Section 2.9.3, "Agent Clustering Worksheet," on page 41
2.9.1 System Clustering Worksheet
Item
1) Software Version Updates
for Cluster:
Worksheet" in
for each location where you will install the NetWare MTA and/or
Locations, mark POA Local to Post Office and MTA Local to Domain. In a
34.
Clustering, mark Yes. This will cause the Agent
Item 7: Post
Offices, refer to the Domain and Post Office Worksheets you
26, and to the IP Address Worksheet you completed during
Now, mark No. You will configure the agents to run in
Explanation
List any servers that need to be updated so that all nodes in
the cluster are running the same version of NetWare.
For more information, see
Version Requirements," on page
"Planning the GroupWise
"Installing GroupWise
"Deciding Where to Install
and
Section 2.4, "Planning a
Section 2.1, "Meeting Software
24.
Planning GroupWise in a NetWare Cluster
Agents", then print
Agents" in the
43.
43.
37
Advertisement
Table of Contents
