Creating A New Secondary Domain In A Cluster - Novell GROUPWISE 7 - INTEROPERABILITY GUIDE Manual

42.3 Creating a New Secondary Domain in a
Cluster
After you have set up the primary domain and initial post office, as described in
"Setting Up a New GroupWise System in a Cluster," on page
secondary domains as needed.
To create a new secondary domain in a Microsoft cluster:
1 Create a domain resource group for the new domain, as described in
Resource Groups" on page
2 Create an MTA service resource for the domain's MTA, as described in
Service Resources" on page
3 Map a drive to the shared disk of the domain resource group
item 7) where the new secondary domain will be created.
4 Manually create the domain directory
This step is not required, but in a clustered environment,
already exists.
5 If you selected the same shared disk with the domain as the agent installation location
Clustering Worksheet item
in Step
or
If you selected c:\grpwise on each node in the cluster, decide which node to install the
agents to first.
6 In ConsoleOne, connect to the primary domain in your GroupWise system, as described in
"Connecting to a
7 Create the new domain, following the steps provided in
"Domains" in the
specific details:
Use the Domain Worksheet you filled out in
Domain," on page 386
In the Domain Database Location field, be sure to browse through the drive you accessed
in
In the Link to Domain field, link the new domain to the primary domain of your
GroupWise system.
The Configure Link option is selected by default. Select TCP/IP Link to the Other
Domain. Refer to the Agent Clustering Worksheet that you filled out in
Unique Port Numbers for Agents in the Cluster" on page 391
address and cluster-unique port numbers that you need to specify in order to configure the
link.
8 Use the Link Configuration tool to change the links from the new domain to all other domains
in the cluster to direct TCP/IP links, following the steps provided in
Protocol between Domains to
Administration
404 GroupWise 7 Interoperability Guide
401.
401.
1), create the drive:\grpwise directory on the drive accessed
3.
Domain" in "Domains" in the
GroupWise 7 Administration
to fill in the fields on the Create GroupWise Domain page.
Step 3 to the domain directory you created in
TCP/IP" in
Guide.
403, you can create additional
(System Clustering Worksheet
(System Clustering Worksheet item
Step 7
GroupWise 7 Administration
"Creating the New
Guide. Keep in mind the following cluster-
Section 41.2, "Planning a New Clustered
Step 4 above.
"Message Transfer Agent" in the
Section 42.2,
"Creating GroupWise
"Creating Agent
7).
is easier if the domain directory
(Agent
Guide.
Domain" in
"Planning Cluster-
for the resource group IP
"Changing the Link
GroupWise 7