Managing The Webaccess Agent In A Linux Cluster - Novell GROUPWISE 7 - INTEROPERABILITY GUIDE Manual

3 Select the cluster node where you want to online the WebAccess Agent cluster resource, then
click OK.
After a moment, the WebAccess Agent cluster resource displays Running in the State column.
4 At the server where the WebAccess Agent is starting, use the following command to see that
the Internet Agent has started:
/etc/init.d/grpwise status webac70a
5 Select the new WebAccess Agent cluster resource, then click Offline.
The State column for the WebAccess Agent cluster resource returns to Offline.
6 Use the same command that you used in
stopped.
7 Repeat
permanently.
8 Continue with
16.5 Managing the WebAccess Agent in a Linux
Cluster
After you have installed the WebAccess Agent in a cluster, you should consider some long-term
management issues.
Section 16.5.1, "Updating GroupWise Objects with Cluster-Specific Descriptions," on
page 203
Section 16.5.2, "Knowing What to Expect in a WebAccess Agent Failover Situation," on
page 204
202 GroupWise 7 Interoperability Guide
Step 2 whenever you are ready to bring the new Internet Agent cluster resource online
Managing the WebAccess Agent in a Linux
Step 4 to verify that the WebAccess Agent has
Cluster.