Installing And Configuring The Mta And The Poa In A Cluster; Installing And Setting Up The Agents In Your Cluster - Novell GROUPWISE 7 - INTEROPERABILITY GUIDE Manual

9 Rebuild the post office database for the new post office, following the steps provided in
"Rebuilding Domain or Post Office
Administration
Worksheet item
The database rebuild is necessary in order to transfer the POA configuration information and
the post office link information into the post office database, because the POA for the new post
office is not yet running.
10 If you want to create a library with its document storage area outside the post office directory,
follow the steps in
"Libraries and
completely finished setting up the clustered post office.
11 Continue with
software for the new post office.
14.4 Installing and Configuring the MTA and the
POA in a Cluster
By following the instructions in
Cluster," on page
as created the initial domain and post office in your GroupWise system. You are now ready to install
and configure the agents on additional nodes and set up the agent software for use in your cluster.
Section 14.4.1, "Installing and Setting Up the Agents in Your Cluster," on page 146
Section 14.4.2, "Changing Agent Paths to Locations on GroupWise Partitions," on page 150
Section 14.4.3, "Configuring GroupWise Cluster Resources to Load and Unload the Agents,"
on page 152
Section 14.4.4, "Setting Up New Instances of the Agents without Installing the Agent
Software," on page 158
If you have added a new secondary domain or a new post office to an existing GroupWise system,
the agent software has already been installed and you simply need to create a new startup file
specific to the new domain or post office. In these circumstances, follow the instructions in
Section 14.4.4, "Setting Up New Instances of the Agents without Installing the Agent Software," on
page 158 instead of completing the tasks above.

14.4.1 Installing and Setting Up the Agents in Your Cluster

The agents must be installed on each node in domain failover list
2) and the post office failover list
"Running the GroupWise Installation Program on the Preferred Node" on page 147
"Running the GroupWise Installation Program on Subsequent Nodes" on page 148
"Testing Your Agent Installation on Each Node" on page 150
After you have installed and tested the agents on each node in the cluster, continue with
Section 14.4.2, "Changing Agent Paths to Locations on GroupWise Partitions," on page
146 GroupWise 7 Interoperability Guide
Databases" in "Databases" in the
Guide. Be sure to browse to the database location
11) through the GroupWise partition.
"Setting Up a Basic
Documents" in the GroupWise 7 Administration

Installing and Configuring the MTA and the POA in a Cluster

Section 14.1, "Setting Up a New GroupWise System in a Linux
143, you installed the MTA and the POA on the first node in your cluster, as well
(Agent Clustering Worksheet item
Library" or "Setting Up a Full-Service
Guide, after you have
(Agent Clustering Worksheet item
5).
GroupWise 7
(under System Clustering
Library" in
to install the POA
150.