Red Hat DIRECTORY SERVER 8.0 Command Reference Manual page 85

Replication Attributes under cn=ReplicationAgreementName, cn=replica, cn="suffixName", cn=mapping tree, cn=config
Parameter
Default Value
Syntax
Example
2.3.8.4. nsDS5ReplicaBindMethod
This attribute sets the method to use for binding. This attribute can be modified.
Parameter
Entry DN
Valid Values
Default Value
Syntax
Example
2.3.8.5. nsDS5ReplicaBusyWaitTime
This attribute sets the amount of time in seconds a supplier should wait after a consumer sends back
a busy response before making another attempt to acquire access. The default value is three (3)
seconds. If the attribute is set to a negative value, Directory Server sends the client a message and an
LDAP_UNWILLING_TO_PERFORM error code.
The nsDS5ReplicaBusyWaitTime attribute works in conjunction with the
nsDS5ReplicaSessionPauseTime attribute. The two attributes are designed so that the
nsDS5ReplicaSessionPauseTime interval is always at least one second longer than the interval
specified for nsDS5ReplicaBusyWaitTime. The longer interval gives waiting suppliers a better
chance to gain consumer access before the previous supplier can re-access the consumer.
Set the nsDS5ReplicaBusyWaitTime attribute at any time by using changetype:modify with the
replace operation. The change takes effect for the next update session if one is already in progress.
Parameter
Entry DN
Valid Values
Default Value
Syntax
Example
2.3.8.6. nsDS5ReplicaChangesSentSinceStartup
This read-only attribute shows the number of changes sent to this replica since the server started.
Description
DirectoryString
nsDS5ReplicaBindDN: cn=replication manager,
cn=config
Description
cn=ReplicationAgreementName, cn=replica,
cn=suffixDN, cn=mapping tree, cn=config
SIMPLE | SSLCLIENTAUTH
The SIMPLE bind method requires a DN and
password.
SIMPLE
DirectoryString
nsDS5ReplicaBindMethod: SIMPLE
Description
cn=ReplicationAgreementName, cn=replica,
cn=suffixDN, cn=mapping tree, cn=config
Any valid integer
3
Integer
nsDS5ReplicaBusyWaitTime: 3
75