Red Hat DIRECTORY SERVER 8.0 Command Reference Manual page 79

Replication Attributes under cn=replica, cn="suffixDN", cn=mapping tree, cn=config
2.3.7.1. nsDS5Flags
This attribute sets replica properties that were previously defined in flags. At present only one flag
exists, which sets whether the log changes.
Parameter
Entry DN
Valid Values
Default Value
Syntax
Example
2.3.7.2. nsDS5ReplicaBindDN
This multi-valued attribute specifies the DN to use when binding. Although there can be more than one
value in this cn=replica entry, there can only be one supplier bind DN per replication agreement.
Each value should be the DN of a local entry on the consumer server. If replication suppliers are using
client certificate-based authentication to connect to the consumers, configure the certificate mapping
on the consumer to map the subjectDN in the certificate to a local entry.
Parameter
Entry DN
Valid Values
Default Value
Syntax
Example
2.3.7.3. nsDS5ReplicaChangeCount
This read-only attribute shows the total number of entries in the changelog and whether they still
remain to be replicated. When the changelog is purged, only the entries that are still to be replicated
remain.
Section 2.3.7.7, "nsDS5ReplicaPurgeDelay"
See
"nsDS5ReplicaTombstonePurgeInterval"
Parameter
Entry DN
Valid Range
Default Value
Syntax
Description
cn=replica, cn=suffixDN, cn=mapping tree,
cn=config
0 | 1
0 means no changes are logged
1 means changes are logged
0
Integer
nsDS5Flags: 0
Description
cn=replica, cn=suffixDN, cn=mapping tree,
cn=config
Any valid DN
DirectoryString
nsDS5ReplicaBindDN: cn=replication manager,
cn=config
Section 2.3.7.10,
and
for more information about purge operation properties.
Description
cn=replica, cn=suffixDN, cn=mapping tree,
cn=config
-1 to maximum 32-bit integer (2147483647)
Integer
69