Table of Contents
Advertisement
When all icons are all illuminated = code is blank; when all
icons are off = "0".
Use the [•] and [–] keys to view the next digit or enter new
4- or 6-digit "user code".
While using the [•] and [–] keys, you can change any digit
by entering a new digit. This will advance you to the next
digit.
To delete a user code, enter [r]-[r]-[r]-[r] for a 4-digit code,
or [r]-[r]-[r]-[r]-[r]-[r] for a 6-digit code.
Step 6
The ready icon will flash indicating you are back at Step 2 above.
If the code is rejected, the sounder will beep 3 times.
Step 7
If another "user code" needs to be programmed, return to Step
4.
Step 8
Press the [#] key while the ready icon is flashing to exit the User
Code Programming Mode.
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user
codes before assigning authority levels.
Step 1
Press [r]-[6]-["Master Arm/Disarm Code"].
N
Someone changing the authority of another person can
only
partitions to which they have access.
Step 2
The ready icon will flash.
Step 3
Enter the 2 digit "user number" to be assigned authority (The
ready icon is constant and the instant icon will flash).
Step 4
Icons illuminated indicate the authority levels assigned to this
code. An explanation of the icons is listed in the following table.
You may toggle (turn on/off) the authority level by pressing the
number for that authority level.
Page 18
add
or
remove
partition
authorization
NX1448E Icon Keypad
for
Hide quick links:
Advertisement
Table of Contents
