Assigning User Code Authority Levels - GE NX-1348E-ICON User Manual

ASSIGNING USER CODE AUTHORITY LEVELS

Assign authority levels to users by following the steps below. Assign user codes before assigning authority levels.
Step 1 Press [r]-[6]-["Master Arm/Disarm Code"].
N Someone changing the authority of another person can only add or remove partition authorization for
partitions to which they have access.
Step 2 The ready led will flash.
Step 3 Enter the 2 digit "user number" to be assigned authority (The ready led is constant and the instant icon will
flash).
Step 4 Icons illuminated indicate the authority levels assigned to this code. An explanation of the icons is listed in the
following table. You may toggle (turn on/off) the authority level by pressing the number for that authority level.
ICON AUTHORITY LEVELS IF ICON 8 IS OFF
1 Reserved
Arm Only
2
3 Arm Only After Closing Time
Master Arm/Disarm (can program other codes)
4
5 Arm/Disarm
6 Bypass Zones
7 Open / Close Reporting
If this icon is on, this code is programmed as a function
8
code. Do not change! Press [#] - [#] to exit.
Step 5 Press the [r] key. The ready led is on constant and instant icon is on constant. This moves you to the partition
enable. (The user has access in partitions that are illuminated.)
Step 6 The illuminated numbers indicate each partition where the user has access. To change any of the partitions
where the user has access, press numbers corresponding to areas where you want to give the user access or deny
access. (Example: If zone icon #2 is lit, then the user is assigned access to partition #2. By pressing the [2] key,
the icon will go off, denying access to partition #2. Refer to the following chart.
ICON PARTITIONS ASSIGNED
1
2
3
4
5
6
7
8
Step 7 When the partitions are assigned, press the [r] key. This returns you to Step 2 previously mentioned. At this
point you may enter another user number to assign authority level. Repeat Steps 3 - 7 until you have assigned
authority levels to all user numbers.
Step 8 Press the [#] key to exit the Assigning Authority Level Program.
NX-1348E-ICON
(Note: Do not change if on.)
Partition 1
Partition 2
Partition 3
Partition 4
Partition 5
Partition 6
Partition 7
Partition 8
g
GE Interlogix
- 13 -