Table of Contents
Advertisement
Step 7
When the partitions are assigned, press the [r] key. This returns
you to Step 2 previously mentioned. At this point you may enter
another user number to assign authority level. Repeat Steps 3 -
7 until you have assigned authority levels to all user numbers.
Step 8
Press the [#] key to exit the Assigning Authority Level Program.
SETTING THE KEYPAD TONE
Step 1
Press [r]-[0]. Keypad is now in the "Adjust Tone" mode.
Step 2
Pressing the [•] key will make the keypad sounder go to higher
tones, pressing the [–] key will make the keypad sounder go to
lower tones.
Step 3
When the desired tone is reached, press the [#] key to set this
tone and exit from the "Adjust Tone" mode.
CHANGE PARTITION – Optional
Step 1
Press [r]-[1].
Step 2
Press a NUMBER key between 1 and 8 to change partitions
momentarily.
Step 3
If no other key is pressed, it will go back to its standard
partition in ten seconds.
Step 4
If another key is pressed, the system will remain in the new
partition until no keys have been pressed for 60 seconds.
VIEW ALARM MEMORY
Step 1
Press [r]-[3].
displayed along with the alarm icon flashing on the keypad.
Page 20
OTHER KEYPAD FUNCTIONS
The zone(s) that created the last alarm will be
NX1448E Icon Keypad
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the NX-1448E - Security NetworX 48-Zone Fixed and is the answer not in the manual?
Questions and answers