Keypad Functions; Arming Your System In The "Away" Mode - GE NX-1448E - Security NetworX 48-Zone Fixed User Manual

Fixed english keypad

Hide thumbs

Table Of Contents

Table of Contents

Trouble conditions are:

Tamper

(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid

"flashing" light for a short period of time, followed by a slow "flashing"

light.)

ARMING YOUR SYSTEM IN THE "AWAY" MODE

AWAY is used when the user is away from the premise and wants the

interior protected.

Step 1

Close all protected doors and windows.

• Ready icon will be on or flashing when all protected zones and

sensors are secure. NOTE: If any zones are bypassed, a sensor

in that zone can be violated without affecting the ready icon.

• The security system will not arm if the not ready icon is on or

flashing.

• If the power icon is off, you have no AC power. Restore power if

possible. If not, contact your installing company listed on page 1

of this booklet for service.

Step 2

Enter your 4 or 6 digit user code to arm the system.

• The armed icon and exit light will illuminate.

• You may now leave the building.

NOTE: The exit light will flash rapidly for the last 10 seconds of the exit

delay as a warning to the user that the exit time is about to expire. The

user may wish to disarm and rearm the system if more time is needed.

NX1448E Icon Keypad

Hardware