Flash Rom; Boot Strap Rom (Seeprom); Nvsram; Diagnostic Components - Intel AXXRMS2AF080 Hardware User's Manual

•
Allows multiple initiators to address a single target (in a fail-over configuration)
through an expander.
For more information, see http://www.lsi.com/.
Note: Some of these chip features may not be supported by Intel
RMS2AF040 and RMS2AF080.

Flash ROM

An 16-MB CFI-compliant flash ROM is used to accommodate RAID firmware and RAID
BIOS Console 2 OpROM.

Boot Strap ROM (SEEPROM)

The serial bootstrap ROM is used to configure the LSI* LSISAS2008 Processor Chip
before the server board configures the PCI Express* registers. The bootstrap ROM sets
the Phase Lock Loop (PLL) dividers, bootstrap configuration, and so on.

NVSRAM

A 32-KB NVSRAM is used to store disk and drive setup information.

Diagnostic Components

LED Placement and Function
The Intel
following LEDs:
•
One surface-mounted heartbeat ("DS1B1: SAS_HB_LED") LED (Green Color) to
indicate LSISAS2008 activity.
•
Another surface-mounted system error ("DS1B2: SAS_FLT_LED") LED (Amber
Color) to indicate a board error.

SAS/SATA Connectors

The Intel
eight internal SAS/SATA signal port connectors.
Intel® Integrated RAID Module RMS2AF040 and RMS2AF080 Hardware User's Guide
®
Integrated RAID Module RMS2AF040 and RMS2AF080 contain the
®
Integrated RAID Module RMS2AF040 and RMS2AF080 provides four and
®
Integrated RAID Module
15