Configuring The Raid Module; Replacing A Controller, Resolving A Config Mismatch - Intel AXXRMS2AF080 Hardware User's Manual

Configuring the RAID Module

To configure the RAID Module, follow these steps:
1. Turn on the system power and check to make sure that the SAS/SATA devices
power up before or at the same time as the system.
2. During the boot, the following BIOS message appears to state the keys that you
need to press to enter the Intel
Press <CTRL><G> to run BIOS Console 2.
This message times out after several seconds. If you miss it, you need to restart the
system.
After you press the keys to enter the Intel
firmware takes several seconds to initialize and then display the Intel
RAID module RMS2AF040 or RMS2AF080 number and firmware version. The
numbering of the RAID module follows the PCI slot scanning order used by the
server board.
3. Follow the instructions in the Intel
Number: D29305-0xx) to configure the RAID module and to install the operating
system drivers.

Replacing a Controller, Resolving a Config Mismatch

To replace the RAID module, see your server system documentation for instructions to
remove and then install an add-in adapter.
If the newly installed RAID module was previously configured, a message appears during
POST, stating that there is a configuration mismatch because the configuration data in the
NVRAM differs from that in the hard drives. Use these steps to resolve the mismatch:
1. Press <Ctrl> + <G> when prompted during boot up to access the BIOS
Configuration Utility.
2. Select Configure > View/Add Configuration to see the NVRAM and drive
configurations.
3. Since the drives contain the correct configuration, use configuration from the disks.
4. Press <Esc> and select YES to update the NVRAM.
5. Exit and reboot.
10
®
RAID BIOS Console 2:
Intel® Integrated RAID Module RMS2AF040 and RMS2AF080 Hardware User's Guide
®
RAID BIOS Console 2 software, the
®
RAID Software User's Guide (Document
®
Integrated