Intel Integrated Raid Module Rms2Af0X0 Hardware Installation; Requirements; Installing The Raid Module - Intel AXXRMS2AF080 Hardware User's Manual

2
Intel
RMS2AF0x0 Hardware Installation

Requirements

•
Intel
standoffs
•
A host system with one available 50-pins PCI Express* 2.0 connector
•
Resource CD, which contains drivers and documentation
•
SAS or SATA 6.0 hard drives
•
Four provided SAS/SATA cables (for cable requirements, see step 6 in
the RAID
Note: Intel Corporation strongly recommends using an uninterruptible power supply (UPS).

Installing the RAID Module

To install the RAID Module, follow these steps:
1. Turn off the power to the system, all drives, enclosures, and system components.
Remove the power cord(s).
2. Remove the server cover. For instructions, see your server system documentation.
3. Insert the three barrel standoffs into the matching holes in the server/workstation
board. To locate the matching module card slot on your server/workstation board,
see your server/workstation board documentation.
The Intel
standoff hole locations could be different (see
4. Attach the Intel
server/workstation board connector, and press the module card firmly to engage the
barrel standoffs installed in step 3 (see
RM2AF080 is shown for illustrative purpose (see
Intel® Integrated RAID Module RMS2AF040 and RMS2AF080 Hardware User's Guide
®
Integrated RAID Module
®
Integrated RAID Module RMS2AF040 and RMS2AF080, with the provided
Module")
®
Server Board SR5520UR is shown for illustrative purpose. Actual
®
Integrated RAID Module RMS2AF0x0 to the matching
Figure 1).
®
Figure 1). The Intel RAID Module
Figure 2).
"Installing
7