Set Enclosure Attribute; Set Enclosure Identification - Dell PowerVault MD3260 Cli Manual

Parameter
criticalPriority
backgroundPriority

Set Enclosure Attribute

This command sets user-defined attributes for an enclosure.
Syntax
set enclosure [enclosureID] (chassisName | assetTag)= "userID"
Parameters
Parameter
enclosureID
chassisName
assetTag

Set Enclosure Identification

This command sets the ID of an enclosure in a storage array.
Syntax
set enclosure ["Service Tag"] id=enclosureID
Parameters
168
Description
percent. For best operation, the value for this parameter
must be less than the value for the
criticalThreshold parameter. Setting this
parameter to 0 disables warning alerts.
This parameter governs the priority for critical
reconstruction activities on the disk pool.
This parameter governs the priority for background task
activities on the disk pool.
Description
Identifies a specific enclosure for which to set the
attribute. Enclosure ID values are 0 to 99. You must put
brackets ([ ]) around the enclosure ID value.
Chassis name or number to give the new enclosure.
Chassis names can be any combination of alphanumeric
characters with a maximum length of 32 characters.
Alphabetical characters can be uppercase or lowercase.
You can also use the underscore character (_) and the
hyphen (‑) character. You cannot use spaces in a chassis
name. You must put quotation marks (" ") around the
chassis name.
Asset tag name or number to give the new enclosure.
Asset tags can be any combination of alphanumeric
characters with a maximum length of ten characters.
Alphabetical characters can be uppercase or lowercase.
You can also use the underscore character (_) and the
hyphen (‑) character. You cannot use spaces in an asset
tag name. You must put quotation marks (" ") around the
asset tag name.