Dell PowerVault MD3260 Cli Manual page 29

Recurring Syntax
nvsram-bit-setting
ipv4-address
ipv6-address
autoconfigure-vols-attr-value-list
autoconfigure-vols-attr-value-pair
create-virtual-disk-copy-attr-value-list
create-virtual-disk-copy-attr-value-pair
recover-raid-virtual-disk-attr-value-list
recover-raid-virtual-disk-attr-value-pair
Table 8. Range of Values for Recurring Syntax Elements
Recurring Syntax
IPV4Priority
IPV4VlanID
IPV6Priority
IPV6VlanID
Syntax Value
nvsram-mask, nvsram-value
(0x hexadecimal, 0x hexadecimal | integer-literal)
(0–255).(0–255).(0–255).(0–255)
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFF)
autoconfigure-vols-attr-value-pair
autoconfigure-vols-attr-value-pair }
{
physicalDiskType=physical disk-type|
raidLevel=raid-level |
diskGroupWidth=integer-literal |
diskGroupCount=integer-literal |
virtualDisksPerGroupCount=
hotSpareCount= integer-literal |
segment-size-spec
segmentSize=
NOTE: The physicalDiskType parameter is not
required if only one type of physical disk is in the
storage array. If you use the
parameter, you must also use the
diskGroupWidth parameters. If you do not use the
physicalDiskType parameter, the configuration
defaults to SAS physical disks.
NOTE: The virtualDisksPerGroupCount parameter is
the number of equalcapacity virtual disks per disk
group.
create-virtual-disk-copy-attr-value-pair
create-virtual-disk-copy-attr-value-pair }
{
copyPriority=highest | high | medium | low | lowest |
targetReadOnlyEnabled=boolean
recover-raid-virtual-disk-attr-value-pair
recover-raid-virtual-disk-attr-value-pair }
{
owner=(0 | 1)
Syntax Values
0 to 7
1 to 4094
0 to 7
1 to 4094
integerliteral |
physicalDiskType
hotSpareCount and
29