Reset Storage Array Sas Phy Baseline; Reset Storage Array Virtual Disk Distribution; Resume Remote Replication - Dell PowerVault MD3260 Cli Manual

Reset Storage Array SAS PHY Baseline

This command resets the SAS physical layer (SAS PHY) baseline for all devices except physical disks, and removes the
list of errors from the .csv file. The .csv file is generated by running the save storageArray SASPHYCounts
command.
NOTE: The reset storageArray SASPHYBaseline command clears error counts for all devices except
the physical disks. After running this command, the .csv file continues to list the DrivePHY errors. All other errors
are deleted from the .csv file.
Syntax
reset storageArray SASPHYBaseline
Parameters
None.

Reset Storage Array Virtual Disk Distribution

This command reassigns (moves) all virtual disks to their preferred RAID controller module.
Syntax
reset storageArray virtualDiskDistribution
Parameters
None.
CAUTION: Ensure that the multipath driver is running before you use this command, or the virtual disk is not
accessible.
NOTE: Under certain host operating system environments, you might be required to reconfigure the multipath host
physical disk. You might also need to make operating system modifications to recognize the new I/O path to the
virtual disks.

Resume Remote Replication

NOTE: This command valid only with Fibre Channel storage arrays.
This command resumes a suspended Remote Replication operation.
Syntax
resume remoteReplication (primary [virtualDiskName] |
primaries [virtualDiskName1 ... virtualDiskNameN])
[writeConsistency=(TRUE | FALSE)]
Parameters
Parameter
primary or primaries
Description
The name of the primary virtual disk for which you want to
resume operation. More than one primary virtual disk
name can be entered. Enclose the primary virtual disk
name in square brackets ([ ]). If the primary virtual disk
name has special characters, the primary virtual disk
155