Configuring A Standard Ip Acl; Figure 3-66 Selecting Acl Type - TP-Link TL-SL5428 User Manual

MAC address and the Ethernet frame type (RFC 1060).
Web – Select Security, ACL, Configuration. Enter an ACL name in the Name field,
select the list type (IP Standard, IP Extended, or MAC), and click Add to open the
configuration page for the new list.
CLI – This example creates a standard IP ACL named david.
Console(config)#access-list ip standard david
Console(config-std-acl)#

Configuring a Standard IP ACL

Command Attributes
• Action – An ACL can contain any combination of permit or deny rules.
• Address Type – Specifies the source IP address. Use "Any" to include all possible
addresses, "Host" to specify a specific host address in the Address field, or "IP" to
specify a range of addresses with the Address and SubMask fields. (Options: Any,
Host, IP; Default: Any)
• IP Address – Source IP address.
• Subnet Mask – A subnet mask containing four integers from 0 to 255, each
separated by a period. The mask uses 1 bits to indicate "match" and 0 bits to
indicate "ignore." The mask is bitwise ANDed with the specified source IP address,
and compared with the address for each IP packet entering the port(s) to which this
ACL has been assigned.
Web – Specify the action (i.e., Permit or Deny). Select the address type (Any, Host,
or IP). If you select "Host," enter a specific address. If you select "IP," enter a subnet
address and the mask for an address range. Then click Add.

Figure 3-66 Selecting ACL Type

Access Control Lists
4-139
3-101
3