Multicast Vlan Registration Commands; Mvr (Global Configuration) - TP-Link TL-SL5428 User Manual

Multicast VLAN Registration Commands

This section describes commands used to configure Multicast VLAN Registration
(MVR). A single network-wide VLAN can be used to transmit multicast traffic (such
as television channels) across a service provider's network. Any multicast traffic
entering an MVR VLAN is sent to all subscribers. This can significantly reduce to
processing overhead required to dynamically monitor and establish the distribution
tree for a normal multicast VLAN. Also note that MVR maintains the user isolation
and data security provided by VLAN segregation by passing only multicast traffic
into other VLANs to which the subscribers belong.
Command
mvr
mvr
show mvr

mvr (Global Configuration)

This command enables Multicast VLAN Registration (MVR) globally on the switch,
statically configures MVR multicast group IP address(es) using the group keyword,
or specifies the MVR VLAN identifier using the vlan keyword. Use the no form of
this command without any keywords to globally disable MVR. Use the no form with
the group keyword to remove a specific address or range of addresses. Or use the
no form with the vlan keyword restore the default MVR VLAN.
Syntax
[no] mvr [group ip-address [count] | vlan vlan-id]
• ip-address - IP address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
• count - The number of contiguous MVR group addresses. (Range: 1-255)
• vlan-id - MVR VLAN ID (Range: 1-4094)
Default Setting
• MVR is disabled.
• No MVR group address is defined.
• The default number of contiguous addresses is 0.
• MVR VLAN ID is 1.
Command Mode
Global Configuration
Table 4-33 Multicast VLAN Registration Commands
Function
Globally enables MVR, statically configures MVR group
address(es), or specifies the MVR VLAN identifier
Configures an interface as an MVR receiver or source port,
enables immediate leave capability, or configures an
interface as a static member of the MVR VLAN
Shows information about the global MVR configuration
settings, the interfaces attached to the MVR VLAN, or the
multicast groups assigned to the MVR VLAN
Multicast VLAN Registration Commands
4
Mode Page
GC 4-304
IC 4-305
PE 4-307
4-303