802.1X Port Authentication; Table 4-35 802.1X Port Authentication - TP-Link TL-SL5428 User Manual

Command Usage
• If you enable port security, the switch stops learning new MAC addresses on
the specified port when it has reached a configured maximum number. Only
incoming traffic with source addresses already stored in the dynamic or static
address table will be accepted.
• First use the port security max-mac-count command to set the number of
addresses, and then use the port security command to enable security on the
port.
• Use the no port security max-mac-count command to disable port security
and reset the maximum number of addresses to the default.
• You can also manually add secure addresses with the mac-address-table
static command.
• A secure port has the following restrictions:
- Cannot use port monitoring.
- Cannot be a multi-VLAN port.
- Cannot be connected to a network interconnection device.
- Cannot be a trunk port.
• If a port is disabled due to a security violation, it must be manually re-enabled
using the no shutdown command.
Example
The following example enables port security for port 5, and sets the response to a
security violation to issue a trap message:
Console(config)#interface ethernet 1/5
Console(config-if)#port security action trap
Related Commands
shutdown (4-171)
mac-address-table static (4-190)
show mac-address-table (4-191)

802.1X Port Authentication

The switch supports IEEE 802.1X (dot1x) port-based access control that prevents
unauthorized access to the network by requiring users to first submit credentials for
authentication. Client authentication is controlled centrally by a RADIUS server
using EAP (Extensible Authentication Protocol).
Command
dot1x system-auth-control
dot1x default
dot1x max-req
dot1x port-control

Table 4-35 802.1X Port Authentication

Function
Enables dot1x globally on the switch.
Resets all dot1x parameters to their default values
Sets the maximum number of times that the switch
retransmits an EAP request/identity packet to the client
before it times out the authentication session
Sets dot1x mode for a port interface
Authentication Commands
Mode
GC
GC
IC
IC
4
Page
4-112
4-112
4-113
4-113
4-111